Search
Products
Foundation Weep Screed
Moisture removal from stucco
Acts as a stop, and is designed with an unperforated flange to allow moisture removal from stucco installations on frame construction at the foundation line.
Stainless Steel Diamond Mesh Lath
when the ultimate corrosion resistance is requiredWhen the highest levels of corrosion resistance are required, a stainless steel substrate for Portland cement or gypsum plaster used in stucco &…
Diamond Security Lath (for Plaster)
A Heavy-gauge lath for Enhanced protection from breachDiamond Security Lath is an expanded steel base used for interior and exterior plaster and stucco reinforcement for secured applications where…
Stainless Steel Self-Furring V-Groove Lath
when the ultimate Self-Furring corrosion resistance is requiredStainless Steel Self-Furring V-Groove Metal Lath is manufactured with five, approximately 1/4" deep, embossed "V" ribs, spaced 6" on…
Mini-Bead™ 800 and 900
Provides superior keying for joint compound for one-coat plaster veneer systemsMini-Bead™ 800 and 900 are fine-mesh corner beads used to provide corner reinforcement for one-coat and two-coat…
E-Screen (Drainage Mat)
Rainscreen Drainage MatClarkDietrich E-Screen can be used in stucco, stone veneer, brick, or under various siding installations to provide an effective method for drainage and ventilation in the wall…
#701A/#801A J-Trim
Provides clean, neat edge protection at gypsum panel terminations for one- and two-coat veneer plaster finishesVeneer trims 701A and 801A are J-shaped trims formed from galvanized steel to fit…
#701B/#801B L-Trim
Applied after panel installation to finish veneer plaster edges at wall terminationsVeneer trims 701B and 801B are L-shaped trims designed for use at junctions of veneer gypsum base with rough…
Self-Furring V-Groove Lath
1/4" self-furring v-groove Expanded Steel Plaster or Stucco BaseSelf-Furring V-Groove Metal Lath is manufactured with five, approximately 1/4" deep, embossed “V” ribs, spaced 6" on center along the…
Paper-Backed Lath
Galvanized Expanded Steel Plaster/Stucco BaseA superior mesh multi-purpose expanded steel base with an approved Grade-D weather resistant barrier attached. Application of asphalt paper-backed (APB)…
3/8" Rib Lath
The most rigid of all expanded metal lath productsA High-Rib Metal Lath with a herringbone mesh pattern and seven, 3/8" deep, longitudinal, solid steel ribs at intervals of 3-7/8" across the sheet.…
Cornerite™
Reinforcement for inside or outside cornersCornerite™ reinforcing angle is used to reinforce all inside or inner plaster corners to reduce corner cracking. Cornerite reinforcing angle is formed from…
Vinyl 3-1/2" Drip Screed w/ Weep Holes and Tape
Relieves moisture from stucco
The DS15-78-25WX is a combination Drip Screed with Casing Bead and Control Joint for use in stucco plane transitions. Install on frame construction for use in…
Striplath
Reinforcement for corners, windows, doors and openingsStriplath is a flat, expanded metal strip used as plaster reinforcement over joints of solid bases and where dissimilar bases join. It is…
CI Weep Track
Directs water drainage
Designed to be used with #1 Corner Bead around windows and doors and at the foundation line.
Sloped Sill Wedge
Trim component used to provide a slope over the sill to direct intruding water to the outside of the weather-resistive barrier
This is not a flashing; it is intended for use in combination with…
Diamond Mesh Lath
Galvanized, Expanded Steel Plaster aND Stucco BaseA superior, multi-purpose expanded steel substrate for Portland cement or widely used for interior and exterior gypsum plaster and stucco & stone…
Self-Furring Dimple Lath
1/4" self-furring, dimpled, Expanded Steel Plaster and Stucco BaseA self-furring expanded dimpled metal lath ideal for interior and exterior use over sheathing, masonry, and other solid surfaces as…
Factory Fabricated Channel Reveals
Create clear channel designs for drywall surfaces
All intersections are manufactured in a controlled factory environment to the highest quality standards.
Factory Fabricated Vinyl Control Joints
Control joint intersections are manufactured in a controlled factory environment to the highest quality standards
Miter cuts are made with precision to ensure proper fit at all connections.
#36 Sill Screed
Exterior Foundation sill screed
A variation of the #7 style screed which allows trowel access underneath the screed to clean excess stucco material. No visible metal is seen below the stucco line.
FHA-7 Weep Sill Screed
Exterior foundation WEEP (sill) screed
The FHA-7 is for hard-coat stucco, thin-veneer stone, and 1-coat stucco over foam applications. Installed at the juncture of the sill and the exterior…
3-1/2" J-Weep High-Back
Used as sill weep screed or at door and window opening
J-Weep High-Back Plaster Stop is a J-shaped, square-nosed trim manufactured from 26-gauge galvanized steel. The 1-3/8" ground is designed for…
Positive Drain Weep Screed
Designed to provide a flashing transition
From stucco, siding, stone over a brick ledge, at a wall transition.
Mid Wall Weep Screed - M Style
Screed with built-in control joint
Accomodates expansion/contraction of the separate substrates.
Mid Wall Weep Screed with Weep Holes/Tape
Designed to relieve stress and assist in controlling cracks in exterior wall finish
Have built-in control joint to accommodate expansion/contraction of the separate substrates.
2" (Nominal) J-Weep Low-Back
Used as a casing stop bead with stucco, stone and E.I.F.S. Systems
2" Nominal J-Weep Low-Back (2-inch back flange) is commonly used as a straight edge plaster stop at the top of doors and windows…
1/4" Drip "V" Screeds
Designed for stucco or plaster soffits when drip and reveal need to be combined
Connector Clips (for Control Joints)
Designed to assist in the alignment of control joints
And to provide a base for caulking.
Straight and Mitered Connector Clips (for Soffit Vents)
Assists in the alignment of soffit vents
Connects multiple sections.
Connector Clips (for Channel Reveals)
Designed to be used with channel reveals as a base for sealants
And to assist in alignment.
DS15 Drip
Used with drip screed and as drip in special conditions
Such as soffits, balconies, etc.
F40 (Female Casing Expansion Joint Compound)
Female casing bead with an expansion slot
Used as a component of expansion joints, vents, reveals, etc.
M40 (Male Casing Expansion Joint Compound)
Male casing bead, used as a component expansion joints
May be used as a drip reveal or a slotted reveal, etc.
M50 (Wide Male Casing Expansion Joint Compound)
Wide male casing bead, used as a component expansion joints
May be used as a drip reveal or a slotted reveal, etc.
F50 (Wide Female Casing Expansion Joint Compound)
Wide female casing bead with an expansion slot
Used as a component of expansion joints, vents, reveals, etc.
V Truss - Walls & Ceilings
wall & ceilings ReinforcingV Truss for Walls & Ceilings is designed to improve the performance of stucco on overhead surfaces.
Colored Vinyl
Color LeadershipIn addition to our standard white vinyl accessories, we’ve taken the lead in stocking vinyl accessories in tan, brown, gray and black that perfectly complement common mortar colors.
Spray Rib Lath
more rigid than diamond lath and helps to prevent Plaster loss3-3/16" wide strips of plain 50lb kraft paper spot attached with glue between the herringbone mesh pattern with seven, 3/8" deep…
Structalath III
Stucco ReinforcingStructa Wire lath is a welded wire lath, engineered to enhance the performance of stucco cladding and is a part of the ClarkDietrich Easy Embedment System.
Twin Trac
Superior Stucco ReinforcingStructalath Twin Trac is an innovative reinforcing lath that simplifies the attachment of lath to wood and steel studs.
Mega Lath
heavy duty ReinforcingMega Lath is a self-furring welded wire that provides heavy-duty reinforcing for both stucco and stone installation.
1-3/4" Weep Screeds (Perforated Flange)
Designed to direct moisture from stucco and to act as a stopInstall on masonry construction where stucco and foundation walls meet.
1-3/4" Weep Screeds (Unperforated Flange)
Designed to direct moisture from stucco and to act as a stopInstall on frame construction where stucco and foundation walls meet.
3-1/2" Weep Screeds
Designed to direct moisture from stucco and to act as a stopInstall on frame construction where stucco and foundation walls meet.