Search
Products
Bullnose Archmaker™ Corner Bead
True, uniform, curved, or arched corner reinforcement with a bullnose design.
Conforms to most arched and curved designs.
Bullnose Corner Bead
3/4" radius bullnose provides hard-to-damage, rust-proof corners
Designed for use in high-traffic areas.
Archmaker™ Corner Bead
Provides true, uniform, curved, or arched reinforcement
Conforms to most arched and curved designs.
Foundation Weep Screed
Moisture removal from stucco
Acts as a stop, and is designed with an unperforated flange to allow moisture removal from stucco installations on frame construction at the foundation line.
Mini-Bead™ 800 and 900
Provides superior keying for joint compound for one-coat plaster veneer systemsMini-Bead™ 800 and 900 are fine-mesh corner beads used to provide corner reinforcement for one-coat and two-coat…
Wide Flange Corner Bead
Wide Flange Corner reinforcement
Wide Flange Corner Bead is designed for deep fills, irregular corners, and for use in conditions, requiring two layers of 5/8" drywall.
E-Screen (Drainage Mat)
Rainscreen Drainage MatClarkDietrich E-Screen can be used in stucco, stone veneer, brick, or under various siding installations to provide an effective method for drainage and ventilation in the wall…
#701A/#801A J-Trim
Provides clean, neat edge protection at gypsum panel terminations for one- and two-coat veneer plaster finishesVeneer trims 701A and 801A are J-shaped trims formed from galvanized steel to fit…
#701B/#801B L-Trim
Applied after panel installation to finish veneer plaster edges at wall terminationsVeneer trims 701B and 801B are L-shaped trims designed for use at junctions of veneer gypsum base with rough…
Cornerite™
Reinforcement for inside or outside cornersCornerite™ reinforcing angle is used to reinforce all inside or inner plaster corners to reduce corner cracking. Cornerite reinforcing angle is formed from…
Vinyl 3-1/2" Drip Screed w/ Weep Holes and Tape
Relieves moisture from stucco
The DS15-78-25WX is a combination Drip Screed with Casing Bead and Control Joint for use in stucco plane transitions. Install on frame construction for use in…
EIFS/DEFS Corner Bead
Designed for use in EIFS and DEFS wall and ceiling systems
These corner beads are hard to damage, rust-proof, and straight.
EIFS/DEFS Bullnose Corner Bead
Designed for use in EIFS and DEFS wall and ceiling systems
These corner beads are hard to damage, rust-proof, and straight, with a soft, rounded aesthetic.
CI Weep Track
Directs water drainage
Designed to be used with #1 Corner Bead around windows and doors and at the foundation line.
#1A Expanded Corner Bead
GALVANIZED STEEL Expanded flange corner bead for exterior cornersA solid nose, all-purpose exterior corner bead. Strong and economical with multiple general use purposes.
#2A Expanded Corner Bead
RIGID, Expanded flange corner bead for exterior cornersA more rigid expanded corner bead for reinforcing plaster/stucco corners when used with masonry and fire proofing beads and columns. The #2A…
Sloped Sill Wedge
Trim component used to provide a slope over the sill to direct intruding water to the outside of the weather-resistive barrier
This is not a flashing; it is intended for use in combination with…
#36 Sill Screed
Exterior Foundation sill screed
A variation of the #7 style screed which allows trowel access underneath the screed to clean excess stucco material. No visible metal is seen below the stucco line.
FHA-7 Weep Sill Screed
Exterior foundation WEEP (sill) screed
The FHA-7 is for hard-coat stucco, thin-veneer stone, and 1-coat stucco over foam applications. Installed at the juncture of the sill and the exterior…
Bullnose X Corner Beads
3/4" radius bullnose corner bead that includes a shorter 1-1/2" flange for narrow returns
Designed for use in high-traffic areas.
#30 Corner Master™ Control Joint
Expanded flange inside corner control joint
#30 Corner Master™ Expansion/Contraction Control Joint (Double-V) is designed to provide stress relief at inside corner intersections on plaster walls.…
Irregular Leg Corner Bead
Provides damage-resistant, rust-proof, and straight corners
Designed with a shorter, 1-1/2" flange for narrow returns.
Zinc Mini-Bead™ 800 and 900
Corner reinforcementZinc Mini-Bead™ 800 and 900 are fine-mesh corner beads used to provide corner reinforcement for one-coat and two-coat veneer plaster systems. 1-1/4" wide fine-mesh flanges…
Standard Corner Bead
Provides hard-to-damage, rust-proof, and straight corners
Open triangles on the flanges allow for full embedment.
3-1/2" J-Weep High-Back
Used as sill weep screed or at door and window opening
J-Weep High-Back Plaster Stop is a J-shaped, square-nosed trim manufactured from 26-gauge galvanized steel. The 1-3/8" ground is designed for…
Inside Corner Control Joint
Used to straighten an inside corner
For a neat, straight edge.
Inside Control Joint (with removable tape)
Designed to relieve stress caused by expansion and contraction
In wall and ceiling inside angles.
Positive Drain Weep Screed
Designed to provide a flashing transition
From stucco, siding, stone over a brick ledge, at a wall transition.
Mid Wall Weep Screed - M Style
Screed with built-in control joint
Accomodates expansion/contraction of the separate substrates.
Mid Wall Weep Screed with Weep Holes/Tape
Designed to relieve stress and assist in controlling cracks in exterior wall finish
Have built-in control joint to accommodate expansion/contraction of the separate substrates.
2" (Nominal) J-Weep Low-Back
Used as a casing stop bead with stucco, stone and E.I.F.S. Systems
2" Nominal J-Weep Low-Back (2-inch back flange) is commonly used as a straight edge plaster stop at the top of doors and windows…
Connector Clips (for Control Joints)
Designed to assist in the alignment of control joints
And to provide a base for caulking.
Straight and Mitered Connector Clips (for Soffit Vents)
Assists in the alignment of soffit vents
Connects multiple sections.
Connector Clips (for Channel Reveals)
Designed to be used with channel reveals as a base for sealants
And to assist in alignment.
DS15 Drip
Used with drip screed and as drip in special conditions
Such as soffits, balconies, etc.
#1A Zinc Expanded Corner Bead
Expanded flange corner bead for exterior cornersA strong, all-purpose exterior corner bead with a solid nose and multiple general use purposes. The zinc finish provides superior corrosion resistance…
Corner Expansion Joint (Outside Corner)
For conditions where the project requires expansion joint movement on outside corners
Parts come preassembled, and may require field alignment.
Corner Expansion Joint (Inside Corner)
For conditions where the project requires expansion joint movement on inside corners
Parts come preassembled, and may require field alignment.
F40 (Female Casing Expansion Joint Compound)
Female casing bead with an expansion slot
Used as a component of expansion joints, vents, reveals, etc.
M40 (Male Casing Expansion Joint Compound)
Male casing bead, used as a component expansion joints
May be used as a drip reveal or a slotted reveal, etc.
M50 (Wide Male Casing Expansion Joint Compound)
Wide male casing bead, used as a component expansion joints
May be used as a drip reveal or a slotted reveal, etc.
F50 (Wide Female Casing Expansion Joint Compound)
Wide female casing bead with an expansion slot
Used as a component of expansion joints, vents, reveals, etc.
V Truss
Corner ReinforcingInnovative Structa V Truss is the result of our continued commitment to providing the best lathing products possible.
Colored Vinyl
Color LeadershipIn addition to our standard white vinyl accessories, we’ve taken the lead in stocking vinyl accessories in tan, brown, gray and black that perfectly complement common mortar colors.
E-Corner Bead
Fully Embedded Corner BeadProvides reinforcement like welded-wire or woven wire laths.
1-3/4" Weep Screeds (Perforated Flange)
Designed to direct moisture from stucco and to act as a stopInstall on masonry construction where stucco and foundation walls meet.
1-3/4" Weep Screeds (Unperforated Flange)
Designed to direct moisture from stucco and to act as a stopInstall on frame construction where stucco and foundation walls meet.
3-1/2" Weep Screeds
Designed to direct moisture from stucco and to act as a stopInstall on frame construction where stucco and foundation walls meet.
1/4" Drip "V" Screeds
Designed for stucco or plaster soffits when drip and reveal need to be combined
Factory Fabricated Channel Reveals
Create clear channel designs for drywall surfacesAll intersections are manufactured in a controlled factory environment to the highest quality standards.
Factory Fabricated Vinyl Control Joints
Control joint intersections are manufactured in a controlled factory environment to the highest quality standardsMiter cuts are made with precision to ensure proper fit at all connections.