Search
Products
Foundation Weep Screed
Moisture removal from stucco
Acts as a stop, and is designed with an unperforated flange to allow moisture removal from stucco installations on frame construction at the foundation line.
CD Holdown
SECURE AND HOLD DOWN SHEAR WALLS TO THE STRUCTURE FOUNDATION
ClarkDietrich holdowns provide cost-effective shearwall attachment and are used to transfer tension loads between floors or from…
ClarkDietrich Moment Clip (MC Series)
Moment connection for knee walls and shear walls to the structure foundation.
ClarkDietrich moment clips are high-performance, cost effective solutions for knee wall-to-foundation connections and…
Stainless Steel Diamond Mesh Lath
when the ultimate corrosion resistance is requiredWhen the highest levels of corrosion resistance are required, a stainless steel substrate for Portland cement or gypsum plaster used in stucco &…
Diamond Security Lath (for Plaster)
A Heavy-gauge lath for Enhanced protection from breachDiamond Security Lath is an expanded steel base used for interior and exterior plaster and stucco reinforcement for secured applications where…
Stainless Steel Self-Furring V-Groove Lath
when the ultimate Self-Furring corrosion resistance is requiredStainless Steel Self-Furring V-Groove Metal Lath is manufactured with five, approximately 1/4" deep, embossed "V" ribs, spaced 6" on…
EasyClip™ A-Series™ End Clip
Used in knee wall connections or to reinforce jamb stud connections at the primary frame
EasyClip™ A-Series™ End Clips are most commonly used to reinforce connections in knee-wall applications or to…
Self-Furring V-Groove Lath
1/4" self-furring v-groove Expanded Steel Plaster or Stucco BaseSelf-Furring V-Groove Metal Lath is manufactured with five, approximately 1/4" deep, embossed “V” ribs, spaced 6" on center along the…
Paper-Backed Lath
Galvanized Expanded Steel Plaster/Stucco BaseA superior mesh multi-purpose expanded steel base with an approved Grade-D weather resistant barrier attached. Application of asphalt paper-backed (APB)…
3/8" Rib Lath
The most rigid of all expanded metal lath productsA High-Rib Metal Lath with a herringbone mesh pattern and seven, 3/8" deep, longitudinal, solid steel ribs at intervals of 3-7/8" across the sheet.…
Vinyl 3-1/2" Drip Screed w/ Weep Holes and Tape
Relieves moisture from stucco
The DS15-78-25WX is a combination Drip Screed with Casing Bead and Control Joint for use in stucco plane transitions. Install on frame construction for use in…
Striplath
Reinforcement for corners, windows, doors and openingsStriplath is a flat, expanded metal strip used as plaster reinforcement over joints of solid bases and where dissimilar bases join. It is…
CI Weep Track
Directs water drainage
Designed to be used with #1 Corner Bead around windows and doors and at the foundation line.
Diamond Mesh Lath
Galvanized, Expanded Steel Plaster aND Stucco BaseA superior, multi-purpose expanded steel substrate for Portland cement or widely used for interior and exterior gypsum plaster and stucco & stone…
Self-Furring Dimple Lath
1/4" self-furring, dimpled, Expanded Steel Plaster and Stucco BaseA self-furring expanded dimpled metal lath ideal for interior and exterior use over sheathing, masonry, and other solid surfaces as…
#36 Sill Screed
Exterior Foundation sill screed
A variation of the #7 style screed which allows trowel access underneath the screed to clean excess stucco material. No visible metal is seen below the stucco line.
FHA-7 Weep Sill Screed
Exterior foundation WEEP (sill) screed
The FHA-7 is for hard-coat stucco, thin-veneer stone, and 1-coat stucco over foam applications. Installed at the juncture of the sill and the exterior…
3-1/2" J-Weep High-Back
Used as sill weep screed or at door and window opening
J-Weep High-Back Plaster Stop is a J-shaped, square-nosed trim manufactured from 26-gauge galvanized steel. The 1-3/8" ground is designed for…
Positive Drain Weep Screed
Designed to provide a flashing transition
From stucco, siding, stone over a brick ledge, at a wall transition.
Mid Wall Weep Screed - M Style
Screed with built-in control joint
Accomodates expansion/contraction of the separate substrates.
Mid Wall Weep Screed with Weep Holes/Tape
Designed to relieve stress and assist in controlling cracks in exterior wall finish
Have built-in control joint to accommodate expansion/contraction of the separate substrates.
2" (Nominal) J-Weep Low-Back
Used as a casing stop bead with stucco, stone and E.I.F.S. Systems
2" Nominal J-Weep Low-Back (2-inch back flange) is commonly used as a straight edge plaster stop at the top of doors and windows…
Holdown Plate (HDP)
SECURE AND HOLD DOWN structural steel endposts between floors or TO THE FOUNDATION
ClarkDietrich HDP holdown plates provide cost-effective shearwall attachment and are used to transfer tension loads…
V Truss - Walls & Ceilings
wall & ceilings ReinforcingV Truss for Walls & Ceilings is designed to improve the performance of stucco on overhead surfaces.
EasyClip™ D & T-Series™ Anchor Clips
Provide cost effective tie-down solutions for knee walls, shear walls and truss connectionsThe EasyClip™ D-Series™ & T-Series™ Anchor Clips are high-performance, cost effective solutions for knee…
Pony Wall
Partial wall framing connection to floorThe ClarkDietrich Pony Wall is intended to support out-of-plane loading of cantilevered partial wall systems that are unsupported at the top track.
Spray Rib Lath
more rigid than diamond lath and helps to prevent Plaster loss3-3/16" wide strips of plain 50lb kraft paper spot attached with glue between the herringbone mesh pattern with seven, 3/8" deep…
Structalath III
Stucco ReinforcingStructa Wire lath is a welded wire lath, engineered to enhance the performance of stucco cladding and is a part of the ClarkDietrich Easy Embedment System.
Twin Trac
Superior Stucco ReinforcingStructalath Twin Trac is an innovative reinforcing lath that simplifies the attachment of lath to wood and steel studs.
Mega Lath
heavy duty ReinforcingMega Lath is a self-furring welded wire that provides heavy-duty reinforcing for both stucco and stone installation.
1-3/4" Weep Screeds (Perforated Flange)
Designed to direct moisture from stucco and to act as a stopInstall on masonry construction where stucco and foundation walls meet.
1-3/4" Weep Screeds (Unperforated Flange)
Designed to direct moisture from stucco and to act as a stopInstall on frame construction where stucco and foundation walls meet.
3-1/2" Weep Screeds
Designed to direct moisture from stucco and to act as a stopInstall on frame construction where stucco and foundation walls meet.
1/4" Drip "V" Screeds
Designed for stucco or plaster soffits when drip and reveal need to be combined