Products


AFCS Series of one-piece soffit vent with a reinforcing rib to key into stucco
3/4" elongated vent holes.


Designed to work on narrow overhangs
Where vents are needed to go against fascia or walls.


Series of one-piece soffit vent with a reinforcing rib to key into stucco
3/4" elongated vent holes.


Available in several grounds and widths
Can be ordered with the 300VFZ clip for installation.


One-piece Soffit Vent designed for plywood, soffit board, and three-coat stucco
Vent clips are provided to connect the soffit vents and assist in alignment.


One-piece soffit vent designed for soffit board
May be combined with Starter Strips / Casing Beads or DEFS Casing Beads.


Continuous, one-piece, combination design like a control joint
Allowing movement of the plaster with a vent area that has a perforated flange to assist with embedment.


J-bead flanges cover the raw edges of soffit board
One-piece soffit vents provide an economical means for venting soffit areas. Vent clips are provided for proper connection and alignment of the soffit vents.


Provides an economical means for venting soffit areas
One-piece soffit vent with perforated flanges to assist in embedment of the base coat mixture and to cover the raw edges of the soffit board. Vent clips are provided for proper connection and to assist in the alignment of the soffit vents.


Continuous one-piece Soffit Vent
Reinforcing rib to key into stucco and plaster. Vertical edge clips are provided for special installations.


Continuous one-piece Soffit Vent
Reinforcing rib to key into stucco and plaster with a perforated flange.


Continuous three-piece Soffit Vent
For stucco and plaster.


Continuous two-piece Soffit Vent
For stucco and plaster with vertical edge clips provided for special installations.


One-piece soffit board designed for venting soffit areas over exterior board in EIFS and DEFS applications
Available with 2", 3", 4" wide vents, each with a 1/8” ground. Vent clips are provided to connect the soffit vent and to assist in the alignment of the soffit vents. Always use a rigid backing or blocking material behind surface mounted reveal.


Designed to address finishing the plaster to the vertical soffit area intersection
When a drip and soffit vent need to be combined.