Exterior Finishing: Vents

AFCS Series of one-piece soffit vent with a reinforcing rib to key into stucco

3/4" elongated vent holes.

Designed to work on narrow overhangs

Where vents are needed to go against fascia or walls.

Series of one-piece soffit vent with a reinforcing rib to key into stucco

3/4" elongated vent holes.

"F" Channel Reveals provide a reveal at the juncture of walls, ceilings, or dissimilar materials

Perforated flange allow the base coat mixture to easily flow through and bond with the substrate.

A variation on the vented channel reveal for when the design style calls for a different aesthetic

The slots function in the same way as the holes on a standard Vented Channel Reveal, allowing air to flow around the perimeter to assist with…

Available in several grounds and widths

Can be ordered with the 300VFZ clip for installation.

One-piece Soffit Vent designed for plywood, soffit board, and three-coat stucco

May be combined with Starter Strips / Casing Beads or DEFS Casing Beads.

Continuous, one-piece, combination design like a control joint

Allowing movement of the plaster with a vent area that has a perforated flange to assist with embedment.

J-bead flanges cover the raw edges of soffit board

One-piece soffit vents provide an economical means for venting soffit areas. Vent clips are provided for proper connection and alignment of the soffit vents. 

Provides an economical means for venting soffit areas

One-piece soffit vent with perforated flanges to assist in embedment of the base coat mixture and to cover the raw edges of the soffit board. Vent clips are provided for proper connection…

Continuous one-piece Soffit Vent

Reinforcing rib to key into stucco and plaster. Vertical edge clips are provided for special installations.

Continuous one-piece Soffit Vent

Reinforcing rib to key into stucco and plaster with a perforated flange.

Continuous three-piece Soffit Vent

For stucco and plaster.

Continuous three-piece Soffit Vent

For stucco and plaster.

Continuous two-piece Soffit Vent

For stucco and plaster with vertical edge clips provided for special installations.

One-piece soffit board designed for venting soffit areas over exterior board in EIFS and DEFS applications

Available with 2", 3", 4" wide vents, each with a 1/8” ground. Vent clips are provided to connect the soffit vent and to assist in the…

"F" Channel Reveals provide a reveal at the juncture of walls, ceilings, or dissimilar materials

Perforated flanges allow the base coat mixture to easily flow through and bond with the substrate.

Vented Channel Reveals facilitate perimeter air flow to assist in moisture management and temperature control

This vent is intended for surface-mount applications. Always use a rigid backing or blocking material behind surface-mounted reveal.

Designed to address finishing the plaster to the vertical soffit area intersection

When a drip and soffit vent need to be combined.

Designed for ceilings when a vented reveal is required at the juncture of a wall and ceiling where horizontal movement may occur

Vent clips are provided to connect reveal sections and to assist in their alignment.