Search
Products
Foundation Weep Screed
Moisture removal from stucco
Acts as a stop, and is designed with an unperforated flange to allow moisture removal from stucco installations on frame construction at the foundation line.
Soffit Vent Control Joint Combination
Continuous, one-piece, combination design like a control joint
Allowing movement of the plaster with a vent area that has a perforated flange to assist with embedment.
"F" Series Control Joint and Vent
Designed to work on narrow overhangs
Where vents are needed to go against fascia or walls.
Vinyl 3-1/2" Drip Screed w/ Weep Holes and Tape
Relieves moisture from stucco
The DS15-78-25WX is a combination Drip Screed with Casing Bead and Control Joint for use in stucco plane transitions. Install on frame construction for use in…
CI Weep Track
Directs water drainage
Designed to be used with #1 Corner Bead around windows and doors and at the foundation line.
Miscellaneous Soffit Vent
One-piece Soffit Vent designed for plywood, soffit board, and three-coat stucco
May be combined with Starter Strips / Casing Beads or DEFS Casing Beads.
#36 Sill Screed
Exterior Foundation sill screed
A variation of the #7 style screed which allows trowel access underneath the screed to clean excess stucco material. No visible metal is seen below the stucco line.
Drip Flashing - 3" and 3-1/2" Flange
Designed to be used above window and door openings or at the foundation line
To assist with moving moisture away from the wall.
FHA-7 Weep Sill Screed
Exterior foundation WEEP (sill) screed
The FHA-7 is for hard-coat stucco, thin-veneer stone, and 1-coat stucco over foam applications. Installed at the juncture of the sill and the exterior…
3-1/2" J-Weep High-Back
Used as sill weep screed or at door and window opening
J-Weep High-Back Plaster Stop is a J-shaped, square-nosed trim manufactured from 26-gauge galvanized steel. The 1-3/8" ground is designed for…
Positive Drain Weep Screed
Designed to provide a flashing transition
From stucco, siding, stone over a brick ledge, at a wall transition.
Mid Wall Weep Screed - M Style
Screed with built-in control joint
Accomodates expansion/contraction of the separate substrates.
Mid Wall Weep Screed with Weep Holes/Tape
Designed to relieve stress and assist in controlling cracks in exterior wall finish
Have built-in control joint to accommodate expansion/contraction of the separate substrates.
DS15 Drip
Used with drip screed and as drip in special conditions
Such as soffits, balconies, etc.
Soffit Vents (One-Piece)
Continuous one-piece Soffit Vent
Reinforcing rib to key into stucco and plaster with a perforated flange.
Soffit Vents (One-Piece with Edge Clip)
Continuous one-piece Soffit Vent
Reinforcing rib to key into stucco and plaster. Vertical edge clips are provided for special installations.
Soffit Vents (Two-Piece Narrow Overhang)
Continuous two-piece Soffit Vent
For stucco and plaster with vertical edge clips provided for special installations.
FCS Soffit Vent
Available in several grounds and widths
Can be ordered with the 300VFZ clip for installation.
Vented Drip Screed
Designed to address finishing the plaster to the vertical soffit area intersection
When a drip and soffit vent need to be combined.
V Truss
Corner ReinforcingInnovative Structa V Truss is the result of our continued commitment to providing the best lathing products possible.
Spray Rib Lath
more rigid than diamond lath and helps to prevent Plaster loss3-3/16" wide strips of plain 50lb kraft paper spot attached with glue between the herringbone mesh pattern with seven, 3/8" deep…
Mega Lath
heavy duty ReinforcingMega Lath is a self-furring welded wire that provides heavy-duty reinforcing for both stucco and stone installation.
1-3/4" Weep Screeds (Perforated Flange)
Designed to direct moisture from stucco and to act as a stopInstall on masonry construction where stucco and foundation walls meet.
1-3/4" Weep Screeds (Unperforated Flange)
Designed to direct moisture from stucco and to act as a stopInstall on frame construction where stucco and foundation walls meet.
3-1/2" Weep Screeds
Designed to direct moisture from stucco and to act as a stopInstall on frame construction where stucco and foundation walls meet.
1/4" Drip "V" Screeds
Designed for stucco or plaster soffits when drip and reveal need to be combined
Soffit Vents (Three-Piece with Edge Clip)
Continuous three-piece Soffit VentFor stucco and plaster.
Soffit Vents (Three-Piece)
Continuous three-piece Soffit VentFor stucco and plaster.
BackerBead® Drip Flashing - 3-1/2" Flange
Drip flashing with built-in closed cell backer rodBackerBead® Drip Flashing - 3-1/2" Flange is designed to provide positive drainage above exterior window and door openings while also providing a…
"F" Series Architectural Soffit Vent
AFCS Series of one-piece soffit vent with a reinforcing rib to key into stucco3/4" elongated vent holes.
Architectural Soffit Vent
Series of one-piece soffit vent with a reinforcing rib to key into stucco3/4" elongated vent holes.