Products


Provides clean, neat edge protection at gypsum panel terminations for one- and two-coat veneer plaster finishes
Veneer trims 701A and 801A are J-shaped trims formed from galvanized steel to fit standard 1/2" and 5/8" gypsum panel depths with grounds to accommodate veneer finishes.


Applied after panel installation to finish veneer plaster edges at wall terminations
Veneer trims 701B and 801B are L-shaped trims designed for use at junctions of veneer gypsum base with rough concrete or masonry ceilings.


Designed to be used with channel reveals as a base for sealants
And to assist in alignment.


Designed to assist in the alignment of control joints
And to provide a base for caulking.


Used with drip screed and as drip in special conditions
Such as soffits, balconies, etc.


Provides superior keying for joint compound for one-coat plaster veneer systems
Mini-Bead™ 800 and 900 are fine-mesh corner beads used to provide corner reinforcement for one-coat and two-coat veneer plaster systems. 1-1/4" wide fine-mesh flanges are tapered along the outer edges to enhance veneer plaster concealment.


Assists in the alignment of soffit vents
Connects multiple sections.

Preferred method where sink or lavatory is to be recessed
A punched metal strip attached to the front edge of the cabinet is used in some geographical areas as a screed and support for the countertop trim.