Exterior Finishing: Control Joints

Recommended for smooth finishes

Removable tape protects deep "V" expansion slot during construction. 

Expanded flange control joint

#15 Expanded Flange Control Joint (Double-V) is used to relieve stresses in large plastered areas of walls, ceilings, and stucco areas. The Double-V Control Joint counteracts the inherent shrinkage during stucco…

CORROSION RESISTANT EXPANDED FLANGE CONTROL JOINT

#15 Expanded Flange Control Joint (Double-V) is used to relieve stresses in large plastered areas of walls, ceilings, and stucco areas. The Double-V Control Joint counteracts the inherent…

Expanded flange inside corner control joint

#30 Corner Master™ Expansion/Contraction Control Joint (Double-V) is designed to provide stress relief at inside corner intersections on plaster walls. The Double-V expansion joint absorbs…

Expanded flange control joint with a taped reveal for a clean finish

#XJ15 Expanded Flange Control Joint (Double-J) is used to relieve stresses in large plastered areas of walls, ceilings, and stucco areas. This expanded wing control joint…

Designed to relieve stress and assist in controlling cracking in large areas of walls and ceilings

Flat flange for thinner, 1-Coat applications. 

Designed to relieve stress and assist in controlling cracking in large areas of walls and ceilings

Also creating 1/4" to 1-1/2" reveal in Stucco.

Recommended for smooth finishes

Removable tape protects the deep "V" groove during construction. J-hooks on the ground helps reduce the effect of plaster shrinkage.

PVC Control Joint with Embeddable Flange design

Designed to relieve stress and assist in controlling cracking in large areas of walls and ceilings. Specially designed connector clips are provided for alignment and base for sealants.

Control joint intersections are manufactured in a controlled factory environment to the highest quality standards

Miter cuts are made with precision to ensure proper fit at all connections. 

Designed to relieve stress caused by expansion and contraction

In wall and ceiling inside angles.

Used to straighten an inside corner

For a neat, straight edge.

Relieves moisture from stucco

The DS15-78-25WX is a combination Drip Screed with Casing Bead and Control Joint for use in stucco plane transitions.  Install on frame construction for use in stucco plane transitions.