


The ClarkDietrich Panel Lift Clip is load rated and is used to safely lift wall panels at assembly warehouses or on job-sites. The clip comes pre-punched for screw attachment to the panel as well as a larger hole for the clamp. The rounded design of the top of the panel clip allows for the clamp to slide freely without getting stuck on the corners. The Panel Lift Clip comes in 12ga and is offered in two sizes, 8” and 12”.
Our Panel Lift Clip is load rated and is used to safely lift wall panels at assembly warehouses or on a job-site. The clip comes pre-punched for screw attachment to the panel as well as a larger hole for the clamp. The rounded design of the top of the panel clip allows for the clamp to slide freely without getting stuck on the corners. The Panel Lift Clip comes in 12ga and is offered in two sizes 8” and 12”.
Product Dimensions
PLC8-97 = 3" wide x 8" long plate
PLC12-97 = 3" wide x 12" long plate
Material Specifications
12ga (97 mil), 0.1017" Design thickness, 0.0966" Min. thickness
Product code | Overall Length | Packaging |
---|---|---|
PLC8-97 | 8" | Bucket of 100 |
PLC12-97 | 12" | Bucket of 50 |
Install the Panel Lift Clips to each side and intermediate points of the panel. For intermediate clip installation, cut a groove large enough to insert the clip through the top track. Quantity, location and anchoring of clips to panel as designed by EOR.
Intermediate clip(s) are required for hoisting the panel. For intermediate clip installation, cut a groove large enough to insert the clip through the top track. Quantity, location and anchoring of clips to panel as designed by EOR.
A spreader bar with intermediate hoisting points is required.
Click the below Product Code to view Submittal/Tech Datasheet.
Product code | Description |
---|---|
PLC8 | Panel Lift Clip |
Submittal sheets for the exact product you're looking for can be created by using ClarkDietrich's SubmittalPro® Product Submittal System.