Head-Patch

sprinkler head patch, standard and flush style

Pre-cut to fit standard sprinkler head safety caps.

Found In:
Interior Finishing > Patches
Application(s): Drywall
Description

Pre-cut to fit standard sprinkler head safety caps and PVC pipes, Head-Patch will not sag on large ceiling mis-cuts. Head-Patch will not fuzz-up during sanding.

  • Pre-cut to fit standard sprinkler head safety caps
  • Repairs and reinforces mis-cut or damaged areas around sprinkler head holes
  • Install in areas where patching cutouts were made too large
  • Sprinkler head replacement patch

Product Data & Ordering Information

Product code Size Hole Size Wholesale Case
Type Bags/Case Pack Cases/Pallet
HP-100 5" dia. 2-1/4" dia. 20 Count Bag 5 bags of 20 24
Installation

Installation

  • To apply, lightly sand area to be repaired.
  • Apply drywall compound 1/8”-1/4" thick directly to back of patch.
  • Place patch over center of repair and wipe down flat to wall using joint knife.
  • Immediately skim-coat patch and let dry.
  • Apply second coat, let dry, and sand.
  • Compound that remains on backside of Head-Patch makes patch very rigid in the damaged area.
  • REPAIRS OVER PAINTED SURFACES - recommend the use of Strait-Flex Super-Bond mixed with all-purpose joint compound to enhance bondability.
Tools: BIM Code & SDS Architectural Specs AIA / CEU
Resources

Storage:

All stored materials shall be kept dry. Materials shall be stacked off the ground, supported on a level platform, and protected from weather and moisture.

 

Submittals

Product Submittal Sheets

Click the below Product Code to view Submittal/Tech Datasheet.

Product Code Description
HP-100, HP-500 Head-Patch

ClarkDietrich SubmittalPro®

Submittal sheets for the exact product you're looking for can be created by using ClarkDietrich's SubmittalPro® Product Submittal System.