Exterior Foundation sill screed

A variation of the #7 style screed which allows trowel access underneath the screed to clean excess stucco material. No visible metal is seen below the stucco line.

Designed to direct moisture from stucco and to act as a stop

Install on masonry construction where stucco and foundation walls meet.

Designed to direct moisture from stucco and to act as a stop

Install on frame construction where stucco and foundation walls meet.

Designed for stucco or plaster soffits when drip and reveal need to be combined

Used as a casing stop bead with stucco, stone and E.I.F.S. Systems

2" Nominal J-Weep Low-Back (2-inch back flange) is commonly used as a straight edge plaster stop at the top of doors and windows over traditional head flashings.

Used as sill weep screed or at door and window opening

J-Weep High-Back Plaster Stop is a J-shaped, square-nosed trim manufactured from 26-gauge galvanized steel. The 1-3/8" ground is designed for use with 1" of foam, lath, and a one-coat, 3/8" proprietary stucco system.

Designed to direct moisture from stucco and to act as a stop

Install on frame construction where stucco and foundation walls meet.

Directs water drainage

Designed to be used with #1 Corner Bead around windows and doors and at the foundation line.

Exterior foundation WEEP (sill) screed 

The FHA-7 is for hard-coat stucco, thin-veneer stone, and 1-coat stucco over foam applications. Installed at the juncture of the sill and the exterior concrete foundation, it allows trapped moisture or water to drain to the exterior of the building.

Moisture removal from stucco

Acts as a stop, and is designed with an unperforated flange to allow moisture removal from stucco installations on frame construction at the foundation line.

Screed with built-in control joint

Accomodates expansion/contraction of the separate substrates.

Designed to relieve stress and assist in controlling cracks in exterior wall finish

Have built-in control joint to accommodate expansion/contraction of the separate substrates.

Designed to provide a flashing transition

From stucco, siding, stone over a brick ledge, at a wall transition.

Relieves moisture from stucco

The DS15-78-25WX is a combination Drip Screed with Casing Bead and Control Joint for use in stucco plane transitions.  Install on frame construction for use in stucco plane transitions.