

Furring Channel for Walls and Ceilings
Easily accommodates rigid insulation and provides for the attachment of gypsum wallboard, veneer or plaster to the interior of masonry walls.
ClarkDietrich Z-furring is used to furr out interior masonry or poured concrete wall substrates and to support rigid polystyrene, mineral, or fiberglass batt insulation while providing a uniform plane for gypsum panel attachment. Z-furring must be installed vertically with the 3/4" flange against the substrate. The type of fastener and spacing will vary based on application. Gypsum wallboard may be installed parallel or perpendicular to the Z-furring. Metal lath should be installed perpendicular to the Z-furring.
- 1-1/4” wide flange for easy screw attachment
- Available in 1”, 1-1/2”, 2”, 2-1/2”, 3" depths and 10’ standard length
- Custom sizes and lengths available
Click on Submittal tab for a link to all of ClarkDietrich's Standard Z-Furring Sizes.
Contact ClarkDietrich Technical Services at 888-437-3244 for custom sizes submittals of Z-Furring.
Alternative Products:
- Z-Girt for Rainscreen Framing (Structural) - Used as a primary rainscreen framing component providing a uniform plane for cladding attachment. Stocked in galvanized steel.
Code Approvals & Performance Standards:
Calculated properties are based on:
- AISI S100-16 North American Specification for the Design of CFS Structural Members
- AISI S220-15 North American Standard for CFS Framing - Nonstructural Members
- Section A4 - Material - Chemical & mechanical requirements (Referencing ASTM A1003/A1003M)
- Section A5 - Corrosion Protection (Referencing ASTM A653/A653M)
- Section C - Installation - (Referencing ASTM C754)
- AISI S240-15 - North American Standard for Cold-Formed Steel Structural Framing
- Section A3 - Material - Chemical & mechanical requirements (Referencing ASTM A1003/A1003M)
- Section A4 - Corrosion Protection (Referencing ASTM A653/A653M)
- Section C - Installation - (Referencing ASTM C1007) SDS & Product Certification Information
- SDS & Product Certification Information
PRoduct submittal SHeets
Click the below Product Code to view Submittal/Tech Datasheet.
Product Code | Description |
---|---|
1" Z-Furring 25ga | Z-Furring Channel |
1" Z-Furring 20ga | |
1-1/2" Z-Furring 25ga | |
1-1/2" Z-Furring 20ga | |
2" Z-Furring 25ga | |
2" Z-Furring 20ga | |
2-1/2" Z-Furring 25ga | |
2-1/2" Z-Furring 20ga | |
3" Z-Furring 25ga | |
3" Z-Furring 20ga |
ClarkDietrich SubmittalPro®
Submittal sheets for the exact product you're looking for can be created by using ClarkDietrich's SubmittalPro® Product Submittal System.
- Contact ClarkDietrich Technical Services at 888-437-3244 for any questions about creating product submittals or using SubmittalPro.